|
The Extrude-O-Couple plastic melt temperature sensor utilizes the Nanmac patented Self-Renewing Thermocouple design with an imbedded thermal junction. This proprietary design provides low millisecond response times to temperature changes. Also, the sensing tip is thermally isolated from the thermocouple housing eliminating conduction error. Therefore, the actual (true) temperature of the plastic melt is measured. Click this link for more information in regards to Selecting the Right Thermocouple. All units can be made with various connectors or leads attached, contact factory with your requirement.
The C8-ME model Extrude-O-Couple is a one-piece stainless steel unit designed for use in small extruder nozzles. The sensing tip contains an exposed two-dimensional thermocouple which is electrically and thermally isolated from the thermowell. It is installed flush with the inside surface of the nozzle throat. Thus, offering no obstruction to plastic flow. A circular microhead connector is firmly attached to the thermocouple. Terminations include various connectors or leads with SS Over-Braid or Flexible Armor conduit. The Nanmac C8-ME model is available in thermocouple calibration types E, J, K, N, or T.
The C8-SE model Extrude-O-Couple is designed to fit into standard holes existing in most nozzles for thermocouple or pressure gauge applications. This thermocouple has a two-piece stainless steel thermowell which allows for better sealing at the conical surface b automatically self aligning even in slightly offset machined holes. Terminations include various connectors or leads with SS Over-Braid or Flexible Armor conduit. The Nanmac C8-SE model comes with a circular microhead connector and is available in thermocouple calibration types E, J, K, N, or T.
The C8-LE model Extrude-O-Couple is designed for use on thick-walled extruder nozzles requiring long thermocouples to fit into deep holes. Also it is designed to fit into holes in most nozzles which are modified to receive thermocouples or pressure gauges. The Nanmac C8-LE model has a three-piece thermowell attached. The length of the spacer must be specified to accommodate your requirements. Terminations include various connectors or leads with SS Over-Braid or Flexible Armor conduit. The C8-LE model is available in thermocouple calibration types E, J, K, N, or T. When ordering specify model number calibration and dimension "L" to the nearest 1/8 inch. Maximum length of dimension "L" is four inches (longer lengths available upon request).
|
